OpenVox DGW-100XR, User Manual

Page: 41 / 60

DGW-100XR User Manual
OpenVox Communication Co.Ltd
39
only ).This is used to keep things from stalling for a long time for a host
that is not available for bad connections.
Language
You may specify a global default language for users. This can be specified
also on a per-user basis. If omitted, will fallback to English(en)
Account Code
You may specify a default account for Call Detail Records (CDRs) in addition
specifying on a per-user basis.
Table 4-3-2 Instruction of
Music on Hold
Options Definition
Mohsuggest The ‘Mohsuggest’ option specifies which music on hold class to suggest to
the peer channel when this channel place the peer on hold. It may be
specified globally or on a per-user or per-peer basis.
Mohinterpret You may specify a global default language for users. This can be specified
also on a per-user basis. If omitted, will fallback to English(en)
Table 4-3-3 Instruction of
Codec Settings
Options Definition
Band Width Specify bandwith of low, medium, or high to control which codes are used
in general
Disallow Fine tune codes here using “allow” and “disallow” clause with specific
codes
Allow Fine tune codes here using “allow” and “disallow” clause with specific
codes
Codec Priority Codec priority controls the codec negotiation of an inbound IAX2 call. This
option is inherited to all user entity separately which will override the
setting in general.
Table 4-3-4 Instruction of
Jitter Buffer
Options Definition
Jitter Buffer Global default as to whether you want the jitter buffer at all
Force Jitter Buffer In the ideal world, when we bridge VoIP channels we don’t want to jitter
buffering on the switch, since the endpoints can each handle this.
However, some endpoints may have poor jitter buffers themselves, so this
option will force to always jitter buffer, even in this case.
Max Jitter Buffers A maximum size for the jitter buffer
Resyncthreshold When the jitter buffer notice a significant change in delay that continue
over a few frames, it will resync, assuming that the change in delay was
caused by a timestamping mix-up. The threshold for noticing a change in
delay is measured as twice the measured jitter plus this resync threshold.