www.openplan.com | 844.OPS.OPS1 | [email protected] | REV 09.12.17
8
S
etting
the
led
diSplay
retracted
height
Press the DOWN button on the Switch until the base reaches its lowest position. Measure the
height of the base from the floor and if the number on the LED display does NOT match your
measurement, follow these steps:
Press and hold the DOWN button again until the LED display reads “RST”.
Press and hold the “M” button (about 5 seconds) until the LED
displays the Hashing starting height. (If the display returns to “RST”
before the next step is taken, repeat this step.)
To change the value of the starting height:
Increase by 0.1 s, press the UP button --------------------------------------
Decrease by 0.1, press the DOWN button --------------------------------
Increase by 1 s, press the “1” button ---------------------------------------
Decrease by 1 s, press the “2” button --------------------------------------
Increase by 10s, press the “3” button --------------------------------------
Decrease by 10s, press the “4” button -------------------------------------
Once the new value is displayed, wait about 5 seconds and the display will return to “RST”.
Finish the reset process by pressing and holding the DOWN button again until the desk lowers a little
bit more, slightly rises and stops. Release the DOWN button. The new starting height value is saved
and your desk is now ready to use.
Note: the LED display has a ±0.1 tolerance.
