Opengear MFC-8322-S, User Manual

Page: 28 / 72

3–2 • MFC-8322-S Setup MFC-8322-S and MFC-OG3-N User Manual (Iss. 01)
Card-edge Controls for the MFC-8322-S
This section provides information on the jumpers, buttons and LEDs for the MFC-8322-S. Refer
to
Figure 3.1 for the location of card control features such as the Alarm Mute button, and the
Alarm Config jumpers.
Figure 3.1 MFC-8322-S Card Controls
1. Alarm Mute Button
The Alarm Mute button on the card-edge of the MFC-8322-S mutes the audio alarm for two
minutes. If a fault condition is still present when the mute time-out ends, the card re-activates the
audio alarm.
2. Alarm Config Jumper
The Alarm Config jumper enables or disables the audio alarm signal. The ALARM LED is still
lit if alarm conditions are occurring, but the audio will be off. Refer to Figure 3.2 and the card
labeling for jumper positions.
Figure 3.2 Alarm Config Jumper — Pin Positions
• Enabled — To enable the alarm feature, set the jumper into Position 1+2 .
• Disabled — To disable the alarm feature, set the jumper into Position 2+3 .
3. DIP Switches
SW1 and SW2 are used in conjunction with the DashBoard menus to set the IP Address of the
MFC-8322-S. Refer to the section “ Configuring the DIP Switches ” on page 3-3 for details.
SW3 is used to override the Master Password for the MFC-8322-S. This password limits access
to the card, and the cards installed in the frame.
4. Card Lock
This lock located near the front edge of the card is used to secure the card in its frame slot.
Note
— The MFC-8322-S provides a single DashBoard connection.
1) Alarm Mute Button 3) DIP Switches
2) Alarm Config Jumper 4) Card Lock
1
2
3
Pin Position
1+2
1
2
3
Pin Position
2+3