Opengear MFC-8322-S, User Manual

Page: 20 / 72

2–6 • Installation MFC-8322-S and MFC-OG3-N User Manual (Iss. 01)
• Check the link/activity LEDs found on the ethernet RJ-45 connectors.
• Verify that you have properly performed each step of this procedure.
• Contact Ross Video Technical Support if you cannot establish a connection.
Custom User Configuration via DashBoard
Once communication has been establish with the Network Controller Card, the network settings
may be further adjusted using the following procedure. Note that the steps are optional, you may
perform as many, or as few, as needed.
To configure the network settings via DashBoard
1.
In DashBoard, display the Device tab of the Network Controller Card by
double-clicking its status indicator in the Basic Tree View .
2.
From the Device tab, select the Network tab.
3.
To change the display name of the frame, enter a new name in the Frame Name field.
4.
To change the Network Time Server address, enter the new IP Address in the NTP
Server field.
5.
To change between Static and DHCP addressing, select an option in the Addressing
Mode area.
6.
Configure the network settings as required:
• IP Address — This is the IP Address of the Network Controller Card.
• Subnet Mask — This is the Subnet Mask address for your LAN.
• Default Gateway — This is the IP Address for connection outside the subnet.
7.
To save the new settings, click
Apply
in the Network tab. The settings are saved
immediately and take effect except when overridden by DIP Switch settings. Clicking
Cancel
reverts to the previous settings.
User Rights Management
If your facility has installed and configured the DashBoard Server and URM feature, you may
need to enter a URM user name and password to access the frame and any of the devices installed
in the frame. For details on configuring and using the DashBoard Server and URM feature, refer
to the
DashBoard Server and URM User Manual .
Operating Tip
— Some settings may require that you configure a DIP Switch
before proceeding. Refer to the chapter “ MFC-8322-S Setup ” on page 3-1, or
“ MFC-OG3-N Series Setup ” on page 4-1 for details.