ACM5504-5-G-W-I Quick Start (520053-Rev 1.1)
Page 1
ACM5504-5-G-W-I
Quick Start Guide
Thank you for purchasing the ACM5504-5-G-W-I appliance. . This Quick Start walks you
through installation and configuration. More details are available in the
User Manual
which can be downloaded from
http://opengear.com/documentation
.
Step1 Check kit contents
ACM5504-5-G-W-I device. One
wireless &
3G antenna.
UTP cables. Straight (319014) & crossover (319015)
DB9F-RJ45s. Rack & DIN rail mount tabs. DIO connector
block. 12V DC power pack. Quick Start.
Step 2 Configure the hardware
Attach rubber feet to base and connect any desired mounting tabs
Screw the 3G antenna on to the main
CELL (M)
connector and screw the wireless
antenna on to the main
WIFI (M)
connector. If you have purchased a 3G
diversity/GPS antenna (or Wi-Fi antenna), screw it on to
CELL A
(or
WIFI A
)
The ACM5504-5-G-W-I works with GSM carriers globally. Your carrier will provide a
SIM card for activating you data plan. Unscrew the SIM card access panel and
insert the SIM card in the bottom SIM slot with contacts facing downward
and the notch to RHS. Then replace the SIM card access panel. Refer User Manual
for multiple SIM installation
Connect the
LAN
Ethernet port on the rear to your network or directly to a computer
for initial setup. Connect any management LAN devices to the
ETHERNET 1-4
ports
Plug your serial console devices into
SERIAL 1-4
(all Cisco-straight compatible RJ45
pin-out). Connect your USB devices to the two
USB
ports
Plug in the green screw terminal block and attach external sensors and DIO
Note:
Refer ACM5500-I Addendum for RS422/485 and DIO details
Apply power
.
The ACM5504-5-G-W-I can now be powered externally by either:
connecting the provided external power pack to the
12VDC
barrel socket or
connecting an external 9 to 24 VAC source to the
12VDC
barrel socket or
conn9V to 30 VDC to
DC PWR
and
GND
on the green terminal block
Note:
If you ordered the -SDC option you’ll have an external DC-DC
power converter (input v/- 36V DC to 72V DC. The
converter power cable/ connector plugs into the
12VDC
socket
The ACM5504-5-G-W-I is ready for activation when the PWR status LED on the front
panel of the unit is lit steady, and the H/B (heartbeat) LED is flashing.
