36724AC
Copyright ©2019 OpenEye.
All Rights Reserved. Information contained in this document is
subject to change without prior notice. OpenEye does its best to
provide accurate information but cannot be held responsible for
typos or mistakes.
23221 E Knox Ave
Liberty Lake, WA 99019
509.232.5261
www.openeye.net
1.
To set all channels, select
Circular
in the channel selection box.
- or - Select a single
channel
from the channel selection box.
2.
Select the
position
you desire the channel to appear in the
sequence.
3.
Type the
sequence duration time
(in seconds) you want each
channel to display.
4.
Set sequence activate to
ON
.
5.
Click
Save
.
NOTE
Sequence Setup is only relevant to spot monitor or local
view only.
Sequence Setup
1.
Click
Setup
, and then click
Software.
2.
Click
Upgrade,
and then navigate to the desired upgrade file,
and then click
OK.
The encoder firmware will update, and then encoder will reboot
upon completion.
Firmware Update
1.
Click
Setup
, and then click
Maintenance
.
2.
Select Reboot or a method of Restore.
• Reboot
- restart the encoder.
• Full Restore
- restore the encoder to factory default
settings, including network settings.
• Partial Restore
- restore the encoder to factory default
settings, excluding network settings.
3.
Click
Yes
(or
OK
) to accept the Restore or Reboot.
Factory Restore and Reboot
1.
Click
Setup
, and then click
Network Setup
.
2.
To use the encoder default IP address, select
Use Fixed IP
Address
(recommended).
a.
Enter the
default IP address
.
b.
Verify the
subnet mask
,
default gateway,
primary
DNS
, and
mac address
for the encoder.
c.
Click
Save.
3.
To automatically assign an IP address, select
Get IP Address
Automatically.
ENCODER SETUP
Network Settings
Date / Time Settings
1.
Click
Setup
.
2.
Select the appropriate
Time Zone
, and then select the desired
date format
.
3.
Select a method of date and time sync.
4.
Click
Save
to apply the changes.
• Sync with NTP Server
- use a specified NTP server and
update interval for the date and time.
• Sync with computer time
- use the PC date and time.
• Manual
- manually enter the date and time.
NOTE:
Sync with NTP Server
is the recommended
Date / Time setting. The NTP server address is
pool.ntp.org
.
Resolution
Sets the resolution of Stream 1 and Stream 2
Bit Rate
Sets the bit rate of Stream 1 and Stream 2
Frame Rate
Sets the frame rate of Stream 1 and Stream 2
GOP
Sets the GOP of Stream 1 and Stream 2
Stream Settings
Video Adjust
Brightness
Contrast
Saturation
Hue
Termination ON or OFF
Camera Setup
Picture Settings
1.
Click
Encoder Setup
.
2.
In the
Monitor Resolution
tab, select a
resolution
.
3.
Click
Yes
to accept the resolution change and restart the
Encoder.
Monitor Resolution
NOTE
HDMI spot-out
resolution options include 1024 x 768,
1280 x 1024, 720p, and 1080p.
NOTE
The Monitor Resolution section applies to spot-out
only.
