128
Vehicle care
4. Detach the safety cable.
5. Lower the holder fully and take out
the spare wheel.
Vehicles with a temporary spare
wheel have a spacer ring between
the temporary spare and the
vehicle underbody.
6. Place the replaced wheel in the
spare wheel holder with the
outside of the wheel facing
upwards.
If a full specification wheel is
stowed, do not fit the spacer ring
between the wheel and the
vehicle underbody.
7. Change the wheel.
8. Lift the spare wheel holder, insert
the safety cable.
9. Lift the spare wheel holder and
engage in the catch. The open
side of the catch must point
towards the rear.
10. Turn the hexagon bolt in the load
compartment floor with the wheel
bolt wrench to raise the spare
wheel holder all the way up.
Temporary spare wheel
Use of the temporary spare wheel
could affect driveability. Have the
defective tyre renewed or repaired as
soon as possible.
Only mount one temporary spare
wheel. Do not drive faster than
50 mph. Take curves slowly. Do not
use for a long period of time.
Only mount one temporary spare
wheel. Do not drive faster than
80 km/h. Take curves slowly. Do not
use for a long period of time.
If your vehicle gets a flat tyre on the
rear while towing another vehicle,
mount the temporary spare wheel in
the front and the full tyre in the rear.
Tyre chains
3
121.
Directional tyres
Fit directional tyres such that they roll
in the direction of travel. The rolling
direction is indicated by a symbol
(e.g. an arrow) on the sidewall.
Summary of Contents for Combo 2011
