Opalum® FLOW series
Opalum® STREAM series
Remote control pairing guide
w w w . o p a l u m . c o m
Step 5:
Move the jumper to the pairing
position to enable pairing
mode. This jumper position is
shown in figure 4.
Step 6:
Re-install the batteries in the battery holder. The remote control LED will now shine
steadily red.
Step 7:
Important:
Make sure the power supply has been disconnected from the control hub
and the wall socket for at least three minutes. Due to the control hubs ultra low
stand by power consumption it is required to leave it disconnected for at least three
minutes to allow it to fully turn off which will allow for a clean re-boot.
Step 8:
Plug the power supply back into the control hub and the wall socket. The remote
control LED will now start flashing red. Red flashing indicates that the remote
control has received pairing information from the control hub. If you are using a
wireless enabled Control Hub its status LED will start flashing white. This is the wireless
configuration mode. Please leave the Control Hub flashing white until it turns off.
Otherwise wireless settings might be messed up.
Step 9:
Remove the batteries from the remote control battery holder.
Step 10:
Re-position the pairing jumper into its normal operating position.
Step 11:
Re-install the batteries into the battery holder.
Step 12:
Re-assemble the remote control front panel and housing. Make sure to align both parts
properly using the alignment tab. The parts will then magnetically snap together. The
pairing procedure is now completed and the system is ready for use.
Remote control pairing guide v1.01
2/2
Fig 5: Align parts using alignment tab
Fig 4: Jumper in pairing position
Jumper in PAIRING mode
