3
problems, please take it to one of the Approved Service Centers in our customer service network. The warranty will be
void in the event of damage arising from improper use.
Do not use this heater in the immediate surrounding of a bath, a shower or a swimming pool.
This movable appliance is designed for use in gardens, and can be used indoor and outdoor. The warranty will not apply
to appliances used for professional usage. Although the heater may be used outdoors, the main plug must only be
connected to the supply indoors.
The heater is provided with an anti-tilt switch will switch off the heater if it is overturned, and will switch it on again
automatically when it is restored to its upright position.
3. VOLTAGE
Before using the appliance at the first time, ensure that your mains voltage corresponds to voltage indicated on the appliance. It
is a class I appliance and must be earthed.
Rated voltage
220-240V~ 50/60Hz
Cable length
3m
4. SAFETY
CAUTION: Before fitting or removing the appliance, ensure that the heater's power line supplying the heater is
disconnected. Check that the power line is connected to a 30mA differential circuit breaker.
This appliance is designed for use in gardens, and any room in your house, including those where there is a risk of
splashing.
The installation and use of your appliance must comply with the applicable standards in your country.
When it is switch on, an electrical heating appliance reaches very high temperature libel to cause burns. Make sure that all
other users are aware of the risks.
If you have any doubts concerning installation possibilities for this heater, please consult a qualified electrician.
Children, the elderly and the infirm may not always be aware of the danger involved in using electrical appliances. Never
allow this appliance to be used without supervision.
The appliance must be positioned so that the plug is accessible. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or similar qualified person in order to avoid a hazard.
The heater must not be located immediately below a socket-outlet.
Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire
risk exists if the heater is covered or positioned incorrectly.
Do not place the appliance close to curtains and other combustible materials.
5. HOW TO ASSEMBLE
Before installing your appliance, you must disconnect the
electrical supply at the circuit breaker.
1)
Insert the lower post assembly (11) into the base
assembly (16) and then fix it tightly by means of
4-M6X30 screw, and insert the clamp (12) into the lower
post (11). (fig.1)