2
/
11
Clean the surface where you intend to mount the Button and the back
of the Button.
Before mounting the Button, please run a test. Put the Chime and
Button where you want to mount. Close all the doors when you test. If
the Chime does not sound, please see- Trouble Shooting.
DO NOT install button on UPVC door frames.
DO NOT install button on Metal surface.
A. Mount the Button with screws
Place the button mounting base on
the required place of the wall.
Drilling holes on the wall (The
arrow on the mounting base points
up).
Screw
the
two
screws
into
mounting base. Push the Button
into the position shown in the
below figure.
Front view Rear view
Carefully push the button down to
the stop.
Installation complete.
B. Or mount the Button with adhesive pad
Peel back one side of adhesive pad. Attach adhesive
pad on the back of the Button.
Peel back the non-adhesive paper.
Press the Button onto the desired positions for about
30 seconds.
5. Operating Instructions
1)
Work Mode
The Chime has been paired to the Button before they left factory. After
installation, it’s ready to work. When you press the Button, the Chime will
sound with indicator light flashing.
2)
Melody Selection
Short press the round button, the tune will change.
Melody Selector
