Tire
Spoke
Spoke
Crank arm
Frame
Frame
Frame
Spoke
Pedal bolt groove
4-2. Ring magnet
(※For Presta valve only, may not be possible depending on rim and valve specifications.)
6. Installation
2. Attach dual lock pad frame.
- Remove the protective film on the back of the dual lock pad and attach it to the inner side
of the rear wheel frame where the sensor is installed.
- Separate the fixing screw at the bottom of the air inlet as shown below.
- Insert the ring magnet first, then insert the fixing screw or small rubber ring to fix it.
A. Sensor and cadence magnet
B. Speed sensor magnet
7. Cautions for park/stop
3. Install sensor & 2nd fix with rubber ring
- Attach the sensor in the direction of the arrow to the dual lock pad for the frame.
(※The sensor attached to the dual lock pad for frame can be detached/attached.)
- Fix the body to the frame one more time using the rubber ring and the body fixing groove.
(see below picture)
Ring
magnet
< Rubber ring>
Fixing screw
Fixing
groove
4-1. Spoke magnets
- Unscrew the screw cap attached to the
spoke magnet, attach it to the spoke so
that the magnet faces the speed sensor,
and then turn the screw cap again to fix it.
(※If the sensor and spoke magnet collide,
attach it to the opposite side.)
For battery life, keep the distance at least 5cm
magnet away from the sensor when park/stop.
Caution
O
X
GOOD
BAD
Color
Saving
mode
Power
on
Green
Red
Green
Red
2
2
3
3
1
-
-
1
-
-
-
Detect
or
Caution
:
Install only one of the ring and spoke magnet.
If both are installed at the same time, it may cause data errors and product failure.
5. Ring magnets can be detected when 5~22mm apart from the speed sensor.
( ※ Refer to‘5.Install position & Check magnet detection’)
Speed sensor
Sensor
Speed
sensor
1. Cadence Magnet Attachment :
Attaches to the pedal bolt groove of the crank arm.
Body
rubber ring
Cadence magnet
Magnet
Magnet
Small rubber
ring
< Fixing screw>
8. LED display status
(※Power saving mode:about 30 min after stop)
Over 10%
Less 10%(Replace battery)
Speed magnet detect (5 times)
Cadence magnet detect (5 times)
※ If battery is insufficient, the product may malfunction.
※ When cadence sensor is detected, it wakes up from power saving mode.
Battery