S li m M e di cal P a n el P C
O N Y X - 1 2 2
Appendix A Miscellaneous A-2
A.1 Programming
ONYX-122 utilizes ITE 8712 chipset as its watchdog timer
controller. Below are the procedures to complete its configuration
and the ONYX initial watchdog timer program is also attached
based on which you can develop customized program to fit your
application.
Configuring Sequence Description
After the hardware reset or power-on reset, the ITE 8712 enters
the normal mode with all logical devices disabled except KBC.
The initial state (enable bit) of this logical device (KBC) is
determined by the state of pin 121 (DTR1#) at the falling edge of
the system reset during power-on reset.
There are three steps to complete the configuration setup: (1)
Enter the MB PnP Mode; (2) Modify the data of configuration
registers; (3) Exit the MB PnP Mode. Undesired result may
occur if the MB PnP Mode is not exited normally.
Summary of Contents for ONYX-122
