onset
®
POWER MONITORING
INSTALLATION GUIDE
14724-D
PAGE 8
© 2011–2013 Veris Industries and Onset Computer Corporation
Veris and the Veris “V” logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Onset, HOBO, HOBOware, and HOBOlink are trademarks or registered trademarks of Onset Computer Corporation.
DISPLAY SCREEN DIAGRAM
QUICK SETUP INSTRUCTIONS
These instructions assume the meter is set to factory defaults. If it has
been previously configured, all optional values should be checked.
1. Press
or
repeatedly until SETUP screen appears.
2.
to the PASWD screen.
3.
through the digits. Use
or
to select the password (the
default is 00000). Exit the screen to the right.
4.
to the S CT (Set Current Transducer) screen.
a.
to the CT V screen. Use
or
to select the voltage mode
Current Transducer output voltage.
b.
to the CT SZ screen and through the digits. Use
or
to
select the CT size in amps.
c.
back to the S CT screen.
5.
to the S SYS (Set System) screen.
a.
to the SYSTM screen. Use
or
to select the System Type
(see wiring diagrams on pages 9–10).
b.
back to the S SYS screen.
6.
(Optional)
to the S PT (Set Potential Transformer) screen. If PTs are
not used, then skip this step.
a.
to the RATIO screen and through the digits. Use
or
to
select the Potential Transformer step down ratio.
b.
back to the S PT screen.
7.
to the S PWR (Set System Power) screen.
a.
to the MX MW screen, which displays the calculated Maximum
System Power for your reference.
b.
back to the S PWR screen.
8.
to the S PULS (Set Pulse) screen to set the scaling factors for Wh,
VARh, and mAh.
a.
to Wh/P screen. Use
or
to set the Wh and VARh per
pulse (the default is 1).
b.
to mAh/P screen. Use
or
to set the mAh per pulse (the
default is 10).
c.
to the mS/P screen, which displays the Pulse Duration Time for
your reference (use 10 mS/P for HOBO products).
d.
back to the S PULS screen.
9. Use
to exit the setup screen and then SETUP.
10. Check that the wrench is not displayed on the LCD.
a. If the wrench is displayed, use
or
to find the ALERT screen.
b.
through the screens to see which alert is on.
For full setup instructions, see the configuration instructions on the following
pages.
