OnQ Technologies Manual 1307541-02
Rev. O - 10/25/02
- 3 -
PARTS NAMES AND FUNCTIONS
Front Panel LED Indications
LED
Status
Description
POWER
ON
Power
On
ON
A valid connection
LINK/ACT
Blinks Receives
packets
ON
Connects to a 100Mbps Fast
Ethernet connection
SPD
OFF
Connects to a 10Mbps
Ethernet connection
Ethernet Ports (1-8)
Ethernet Ports with MDI/MDIX auto crossover capacity.
Power Port
Connect to the External power adapter.
Installation
1.
Select the location in the enclosure to allow easy access of
the input and output cables.
2.
Align the tabs on the module with the slots in the
enclosure. Insert the tabs by angling the module away
from the back of the enclosure.
3.
Rotate the module and insert the plunger/grommet on the
module into the corresponding hole on the back plane of
the enclosure. (Plunger must be in pulled out position for
it to engage the hole)
4.
Push the plunger in to lock the module in place. Pull on
the module to ensure the module is locked properly in
place.
5.
Connect cables to appropriate port on the network interface module using Cat 5 jumpers, part number 363201-XX
6.
Plug in power adapter and connect to switch
The switch is considered a “plug and play” network device and requires no special setup except for the appropriate power adapter
and
cables.
7.
Verify if the power (POWER) LED is on. If the POWER LED does not light up, check the power cord and power outlet to verify its
connection. If it still remains unlit, contact your dealer for support.
Ethernet Port Connection
Connect user machines, servers, another switch or any other devices, to the Ethernet ports on this switch with either straight through or
crossover Ethernet cables
.
