OnPoint OPG7KE17SSPSS, Owner'S Manual

Page: 2 / 8

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
WARNING
Read all safety instructions before using the product. Failure to follow these instructions may
result in fire, electrical shock, serious injury, or death.
IMPORTANT SAFETY INFORMATION
General
• READ ALL INSTRUCTIONS
• To avoid a risk of burn, never touch hot surfaces and/or hot
water. Always use handles or knobs.
•
WARNING
To prevent fire, electric shock, and
personal injury, do not immerse the product, its cord, its plug
or its power base in water or other liquid.
• When using electrical appliances ALWAYS follow basic
safety precautions to reduce risk of fire, electric shock, injury
to persons.
• This product is intended for household use only.
• Do not place on or a near a hot gas or electric burner, or in a
heated oven.
• Close supervision is necessary when any appliance is used
by or near children.
• To avoid risk of scalding, do not open the lid while the water
is heating.
• Heater may remain hot after the kettle is turned off.
Power Cord
• Never operate a product whose power cord and/or plug are
damaged.
• The replacement and repairs of the power cord must be
conducted by the manufacturer, its service agent, or similarly
qualified persons in order to avoid hazard.
• If an extension cord is used, the marked electrical rating of
the extension cord must be at least as great as the electrical
rating of the appliance.
• Do not operate the appliance with wet hands or while
standing on a wet floor.
• Never pull on the cord. This may damage the cord and
increase the risk of electric shock.
• Do not let cord hang over edge of table or counter. Do not
let the cord touch any hot surface.
Using the Kettle
• Do not immerse the unit in water or a dishwasher for
cleaning purposes.
• Do not try to block the steam from emitting through the spout
(Not sure if this applies to our unit)
• Keep appliance at least 4 inches away from walls and other
objects while operating. Place the appliance on a heat
resistant surface. Do not put anything on top of the appliance
during operation.
• Never operate a product after it malfunctions or has been
dropped or damaged in any manner.
• Never use accessories which are not recommended by the
manufacturer, including external timers. They could pose a
safety risk to the user and might damage the appliance. Only
use original parts and accessories.
• Do not use outdoors.
• Always unplug the product when not in use and before
cleaning. Allow to cool before touching the product, putting
on or removing parts and before cleaning.
• To disconnect, turn the product off and remove the plug from
the wall outlet.
• Do not use appliance for other than intended use.
• ONLY use the product for heating water. Liquids other than
water will tarnish the inside of the product and void the
warranty.
• Never let the product boil dry.
• To prevent circuit overload, do not plug another high wattage
appliance into the same circuit.
• Make sure the lid is securely in place while the water is
heating up and when pouring it out.
READ AND SAVE THESE INSTRUCTIONS
3
ELECTRICAL CORD
NOTE: If the power cord is damaged, please contact the warrantor listed in the back of this manual.
The particular length of the power cord of this appliance is meant to reduce the risk of becoming tangled in it and/or tripping on
it. Should the length of this cord be insufficient, use an approved extension cord. The marked electrical rating of the extension
cord shall be equal to (or greater than) that of the appliance. If the appliance is of the grounding type, the extension cord should
be a grounding type, 3-wire cord. Lay the extension cord down so that it will not hang down from tabletop or countertops where
it can be pulled on by children or create risk of tripping over it.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended
to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to modify the plug in any way.
SAFETY
IN
F
O
R
M
A
T
IO
N