Onkyo TX-SR701E Service Manual Download Page 3

Page: 3 / 80

2. To initialize the unit

This device employs a microprocessor to perform various
functions and operations. If interference generated by an external
power supply, radio wave, or other electrical source results in
accident which causes the specified operations and functions to
operate abnormally.
To perform a result, please follow the procedure below.

1.Press and hold down the VIDEO-1 button, then press the
STANDBY/ON button.
2.After "CLEAR" is displayed, the preset memory and each
mode stored in the memory, such as surround, are
initialized and will return to the factory setting.

3. Safety-check out

(U.S.A. model only)
After correcting the original service problem, perform the
following safety check before releasing the set to the customer.
Leakage Current Check
Measure leakage current to a known earth ground(water pipe,
conduit, etc.) by connecting a leakage current tester between
the earth ground and exposed metal parts of the appliance
(input/output terminals, screwheads,metal overlays, etc.).
Plug the power supply cord directly into a 120V AC 60 Hz outlet
and turn Standby switch on. Any current meausred must not
exceed 0.5mA.

1. Replacing the fuses

This symbol located near the fuses indicates that the

fuse used is fast operating type. For continued protection against
fire hazard, replace with same type fuse. For fuse rating refer to
the marking adjacent to the symbol.

Ce symbole indique que le fusible utlise est a rapide.

Pour une protection permanente, n'untiliser que fusibles de
meme type. Ce darnier est la qu le present symbol est
appse.

4.Setting the voltage selector (Worldwide models
only)

Worldwide models are equipped with a voltage selector to conform
with local power supplies. Be sure to set this switch to match the
voltage of the power supply in your area before plugging in the unit.

Determine the proper voltage for your area: 220-230 V or 120 V. If
the preset voltage is not correct for your area, insert a screwdriver
into the groove in the switch. Slide the switch all the way to the
upper (120 V) or to the lower (220-230 V), whichever is appropriate.

5.Setting the AM tuning step frequency

(Worldwide models only)

CIRCUIT NO. PART NO. DESCRIPTION

Note: <D>:120V model only
<O>: Other models except 120V model
<T>: Asian model only for 230V
<R>: Chinese model only

<Q>: Hongkong model only

To display the Hardware Config menu:

1. Display the main menu.

2. Use the

and cursor buttons to select "1. Hard

Config" and then pr ess the ENTER b utton. The

"Hardware Config" menu appears.

e. AM Fr equency Step
This setting only appears on the worldwide model.
It determines the increment amount or decrement amount
when adjusting the AM tuner frequency.

The initial setting is 9 kHz, and this needs only to be changed

unit in a 10-kHz region.

if you are using the

* Menu *****************

1.Speaker Config
2.Speaker Distance
3.Level Calibration
4.Input Setup
5.OSD Setup
6.Preference

1.Hardware Config
***********************

a.Surr/Zone 2:Surr
b.Surr Back : 1ch
c.IR IN Position
:Main
d.TV Format :Auto
e.AM Frequency Step
:9kHz

Quit:|SETUP|

INPUT 1

INPUT 2

OUTPUT

COMPONENT VIDEO

OPTICAL

FRONT