COMMON
SAFETY INFORMATION
5
4
3
2
1
6
D
C
A
B
D
C
A
B
5
4
3
2
1
6
SAFETY INFORMATION
This service manual is intended for qualified service technicians; it is not
meant for the casual do-it-yourselfer. Qualified technicians have the
necessary test equipment and tools, and have been trained to properly and
safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of
the product and may void the warranty. If you are not qualified to perform the
repair of this product properly and safely, you should not risk trying to do so
and refer the repair to a qualified service technician.
WARNING
This product may contain a chemical known to the State of California to cause cancer, or birth
defects or other reproductive harm.
Health & Safety Code Section 25249.6 - Proposition 65
1. SAFETY PRECAUTIONS
The following check should be performed for the continued protection of the customer and
service technician.
LEAKAGE CURRENT CHECK
Measure leakage current to a known earth ground (water pipe, conduit, etc.) by connecting
a leakage current tester such as Simpson Model 229-2 or equivalent between the earth ground
and all exposed metal parts of the appliance (input/output terminals, screwheads, metal
overlays, control shaft, etc.). Plug the AC line cord of the appliance directly into a 120 V AC 60
Hz outlet and turn the AC power switch on. Any current measured must not exceed 0.5 mA.
ANY MEASUREMENTS NOT WITHIN THE LIMITS OUTLINED ABOVE ARE INDICATIVE OF
A POTENTIAL SHOCK HAZARD AND MUST BE CORRECTED BEFORE RETURNING THE
APPLIANCE TO THE CUSTOMER.
2. PRODUCT SAFETY NOTICE
Many electrical and mechanical parts in the appliance have special safety related
characteristics. These are often not evident from visual inspection nor the protection afforded
by them necessarily can be obtained by using replacement components rated for voltage,
wattage, etc.
Replacement parts which have these special safety characteristics are identified in this Service
Manual.
Electrical components having such features are identified by marking with a ! on the
schematics and on the parts list in this Service Manual.
The use of a substitute replacement component which does not have the same safety
characteristics as the ONKYO recommended replacement one, shown in the parts list in this
Service Manual, may create shock, fire, or other hazards.
Product Safety is continuously under review and new instructions are issued from time to
time. For the latest information, always consult the current ONKYO Service Manual. A
subscription to, or additional copies of, ONKYO Service Manual may be obtained at a nominal
charge from ONKYO.
(FOR USA MODEL ONLY)
Leakage
current
tester
Reading should
not be above
0.5 mA
Device
under
test
Test all
exposed metal
surfaces
Also test with
plug reversed
(Using AC adapter
plug as required)
Earth
ground
AC Leakage Test
