6
To Play a Tape
• Check once again that all connections have been completed exactly as indicated in the connections diagram and then plug in the AC
power cord.
• After turning the power on, the display illuminates and the
g
PAUSE indicator flashes (about 5 seconds). While the indicator is
flashing, no operation can be performed.
• This deck holds two cassettes at once. Both Deck A and Deck B are capable of auto-reverse playback.
• Tapes can be played back using either Deck A or Deck B. Follow the procedure on Deck A or B. (Deck A is pictured.)
3
Listening to a tape
1. Press the EJECT button to open
the cassette holder.
2. Insert a cassette.
• The side of the cassette with the
exposed tape should be facing down-
ward.
3. Set the Dolby NR by pressing
the DOLBY NR button repeat-
edly until the proper Dolby NR
indicator (OFF, B or C) turns on.
• Select the same noise reduction system
that was used when the cassette was
recorded. For instance, tapes recorded
using Dolby B NR should be played
back with Dolby B NR.
4. Set the Reverse Mode by press-
ing the REVERSE MODE button
repeatedly until the desired
mode is displayed.
(
v
) one side: Only one side of the
tape is played back.
(
b
) repeat: Both sides of the tape are
played back repeatedly eight
times or until the
e
button is
pressed.
5. Start playback.
• Press the
a
or
s
button depending
on which side of the cassette you wish
to listen to.
s
: Playback starts from the front
side.
a
: Playback starts from the reverse
side.
• The auto-stop mechanism will auto-
matically stop the tape (depending on
the tape transport mode) if a tape is
played through to the end.
1
4
5
Stopping playback
Press the
e
button.
2
DOLBY NR
OFF
B
C
DOLBY NR
REVERSE MODE
EJECT
2
1
5
3
4
d,f
(DECK A)
d,f
(DECK B)
