En-
3
Precautions
1. AC Fuse
The fuse is located inside the chassis and is not userser-
viceable. If power does not come on, contact your Onkyo
authorized service station.
2. Care
From time to time you should wipe off the cabinet with
a soft cloth. For heavier dirt, dampen a soft cloth in a
weak solution of mild detergent and water, wring it out
dry, and wipe off the dirt. Following this, dry immedi-
ately with a clean cloth. Do not use rough material, thin-
ners, alcohol or other chemical solvents or cloths since
these may damage the finish or remove the panel letter-
ing.
Use a vacuum cleaner to remove dust from hard-to-reach
grilles.
3. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST
TIME, READ THE FOLLOWING SECTION CARE-
FULLY.
The voltage of the available power supply differs accord-
ing to country or region. Be sure that the power supply
voltage of the area where this unit will be used meets the
required voltage (e.g., AC 220–240 V, 50/60 Hz) written
on the rear panel.
Auto standby function does not fully shutdown the
SKW-501. If you do not intend to use the SKW-501,
remove the power cord from the AC outlet.
The power cord plug is used to disconnect this unit from
the AC power source. Make sure that the plug is readily
operable (easily accessible) at all times.
Package Contents
Make sure your box contains all of the items below. If
anything is missing, contact the nearest Onkyo dealer.
• 2 front speakers (SKF-501F) with removable stands
and cables (3 m)
• Subwoofer (SKW-501)
• RCA cable for connecting the subwoofer (3 m)
• 4 floor pads for the subwoofer
• 8 rubber spacers for the front speakers
The alphabet displayed at the end of the product name
found in catalogs and on package represents the color of
the system. Though the color varies, the specifications
and operations are the same.
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
K. MIYAGI
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
corresponding technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
HTP501̲En.fm Page 3 Tuesday, September 18, 2007 2:10 PM
