background image

E

n

Thank you for your purchase of the Onkyo speaker system. 
Please read this manual thoroughly before using it.
Following the instructions in this manual will enable you to 
obtain optimum performance and listening enjoyment from 
your new speaker system.
Please retain this manual for future reference.

Before using this unit

  The speaker cabinet is made of wood and is therefore sensitive to 

extreme temperatures and humidity. Avoid placing the speaker 
systems in locations subjected to direct sunlight, or in smoky or in 
humid places, such as near an air conditioner, humidifi er, bathroom, 
or kitchen. Doing so may result in damage to the speaker.

  Place the unit on a rigid, level surface. Placing it on a slanted 

surface or weak base not only may cause the unit to fall, but 
also results in decreased sound quality. 

  Be sure to turn off your amplifi er before connecting the speaker 

system. Connecting them with the amplifi er's power on may result 
in damage to the amplifi er or the speaker system.

  Keep water or other liquids away from the unit. If water is spilled 

into the unit, not only the unit but also the speakers themselves 
may be damaged.

Precaution on use

  This speaker system can handle the specifi ed input power when 

it is used for ordinary music reproduction. If the following abnormal 
signals are fed to the speaker, however, an overcurrent may 
fl ow in the internal circuits, causing burning or breakage of the 
wires even if the input power is below the specifi ed rating.
1.   Noise produced when FM station is not tuned in
2.   Sound produced when fast-forwarding cassette tape deck
3.  High-frequency sound generated by an oscillator, an 

electronic musical instrument, etc.

4.   Oscillating amplifi er signals
5.   Special test signals produced by audio checking CD, etc.
6.   Sound produced when connecting or disconnecting audio 

connection cables (Always turn off the amplifi er’s  power 
before connecting or disconnecting cables.)

7.   Howling when a microphone is used

  Do not place magnetic objects such as screwdrivers and iron 

parts near the tweeter since they use speakers with strong 
magnets. Otherwise, the objects may be attracted, causing 
injury or damaging the diaphragm.

Model name

Center speaker system 

SKC-4700 

×

 1

Surround speaker system 

SKM-4700 

×

 2

Connections

  Turn the sound volume to the minimum and disconnect the power 

cord from the amplifi er before connecting the speaker cables.

  The nominal impedance of this speaker system is 8 

Ω

. Use 

only amplifi ers capable of handling this impedance.

  Use the supplied speaker cables to connect between speaker’s 

input terminals and the amplifi er’s speaker 
terminals as illustrated on the right.

  Connect the speaker cables securely to the 

terminals, with the core wires twisted 
properly. In this case, make sure that the 
core wires do not touch each other. Note 
that a short circuit in core wires may result 
in damage to the amplifi er. 

Instruction Manual

SKS-4700

SPEAKER SYSTEM

Connecting to AV amplifi er

Before turning on the amplifi er’s power switch:

  Make sure that the positive (+) and negative (-) speaker cables 

do not contact each other. Otherwise, a short-circuit may occur, 
causing damage to the amplifi er.

  Be sure to connect the speaker cables with correct polarity 

(connect the speaker’s positive (+) and negative (-) binding 
posts with the amplifi er’s corresponding speaker terminals). 
Reversed polarity results in impaired bass-range reproduction, 
causing mislocalization of the sound image. Also, be sure to 
connect the Right and Left speakers with the amplifi er’s 
corresponding speaker terminals. 

  Pull lightly on the speaker cables to ensure that they are 

connected fi rmly.

L

R

SURROUND BACK 

SPEAKER

SURROUND

SPEAKERS

FRONT

SPEAKERS A

CENTER

SPEAKER

+

+

+

+

+

1.  Strip the insulation of speaker cables, 

and twist the core wires tightly.

2.  While pressing the lever, insert the 

wire into the hole, and then release 
the lever.

3.  Make sure that the terminals are 

gripping the core wires, not the 
insulation.

Green

Blue

Gray

SKF-4700 
Front right speaker

SKF-4700 
Front left speaker

SKM-4700 
Surround right speaker

SKM-4700 
Surround left speaker

AV amplifi er

Red

White

SKC-4700 
Center speaker

Summary of Contents for SKS-4700

Page 1: ...lace magnetic objects such as screwdrivers and iron parts near the tweeter since they use speakers with strong magnets Otherwise the objects may be attracted causing injury or damaging the diaphragm Model name Center speaker system SKC 4700 1 Surround speaker system SKM 4700 2 Connections Turn the sound volume to the minimum and disconnect the power cord from the amplifier before connecting the sp...

Page 2: ...0minutesandthenturnitonagain Thisactivates theself demagnetizingfunctionoftheTVset improvingthedisplay condition Ifdiscolorationpersistsevenafterperformingthisremedy move the speaker apart from the TV set Discoloration may also be caused when a magnet or other magnetizing object exists near the TV set because of the combined effect Speaker care Your Onkyo speakers are finished with a very high qua...

Page 3: ...等产生的高频音响 4 振荡的放大器信号 5 由音频测试CD等产生的特殊测试信号 6 在连接或拆除音频连接线时产生的声音 请务必在连接或 拆除连接线前关闭放大器的电源 7 使用麦克风时的反馈啸声 请勿将螺丝刀等磁性物体和铁制物品放置在扬声器系统附近 因为它们会通过强磁场影响扬声器系统 或者 它们可能会被 磁性吸至扬声器上 导致振动膜的损伤或彻底损坏 型号名称 中心扬声器系统 SKC 4700 1 环绕声扬声器系统 SKM 4700 2 使用手册 SKS 4700 扬声器系统 连接 在连接扬声器连接线之前 请先将放大器音量调至最小 并拔 出放大器的电源线 本扬声器系统的额定阻抗是8Ω 请只使用对应于此阻抗的放 大器 如右图所示 使用随机附带的扬声器连接 线 连接扬声器的输入端子和放大器的扬声 器端子 连接扬声器连接线时 请正确地缠绕芯线 将其牢固地连接在端子上 这时 请确认芯 线没有相互接触 ...

Page 4: ...nkyo com ONKYO EUROPE UK Office Suite 1 Gregories Court Gregories Road Beaconsfield Buckinghamshire HP9 1HQ UNITED KINGDOM Tel 44 0 1494 681515 Fax 44 0 1494 680452 ONKYO CHINA LIMITED Unit 1 12 9 F Ever Gain PlazaTower 1 88 Container Port Road Kwai Chung N T HONG KONG Tel 852 2429 3118 Fax 852 2428 9039 http www ch onkyo com C Copyright 2007 ONKYO CORPORATION Japan All rights reserved http www on...

Reviews: