![background image](http://html1.mh-extra.com/html/onkyo/rbx-500/rbx-500_instruction-manual_1636851006.webp)
En-6
How to use Remote controller
Remove the insulation sheet before use.
When using the remote controller, point it toward the
remote control sensor, as shown below.
Notes:
• If the light receiving area is exposed to strong light
such as direct sunlight or inverter fluorescent, the
remote controller may not work.
• If another infrared device is nearby or another
remote controller is used at the same time, the
remote controller may not work correctly.
Place for installation
Use in a place exposed to direct sunlight or a steriliza-
tion lamp may cause discoloration by influence of
ultraviolet rays.
To enjoy the 3D sound effect, it is recommended to
install the unit in a free and open area.
Battery change
In replacing the battery, ensure to use the specified
model.
1
With pushing the stopper in sideways,
pull out the battery holder.
2
Place a lithium battery on the battery
holder, and return the holder into the
remote control until it clicks.
Notes:
• Specified battery model must be used; other-
wise you have a risk of a burst.
• A battery must be kept away from children. In
case a child swallows a battery, consult a physi-
cian immediately.
• Do not attempt to recharge, short-circuit, dis-
assemble, heat the battery, or put it in fire. It
may cause overheat, burst or fire.
• If you do not use the remote controller for a
long time, remove the battery from it to avoid
a damage caused by a fluid leak or corrosion.
Insulation sheet
20°
20°
30°
30°
Approx. 5 m
(16.4 ft.)
Backside of
remote controller
Stopper
Plus (+) marking is
on the upper side
Battery model