NC-500
ADJUSTMENT & CONFIRMATIONS OF OPERATIONS
ADJUSTMENT OF FREQUENCY
a) Turn C702 CCW to set minimum position before POWER ON.
b) Set the frequency at P702 to 32768Hz by adjusting C702 under the condition of no input and no load,
immediately after POWER ON.
c) After 4 ~ 6 minutes of heat running, re-adjust by following b.
INITIAL SETTING FOR SHIPPING
1. Initialization of memories
Press STANDBY/ON button while pressing down INPUT button when the unit is POWER ON,
then the FLT displays "CLEAR", and turn to STAND-BY. Remove power cord from power line.
2.
Other
settings
Pull out the AC cord at the standby mode.
OPERATIONS OF SPEAKER RELAYS
The relay shall be ON about 5 seconds after POWER is ON and shall be OFF immediately after
POWER is OFF.
Summary of Contents for NC 500 - NetTune Receiver
