Connections
En-16
With
u
(Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
u
, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
u
, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver’s remote controller to
control your other
u
-capable Onkyo components,
pointing the remote controller at the AV receiver’s
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(
➔
page 54
).
Note
• Use only
u
cables for
u
connections.
u
cables are supplied
with Onkyo components.
• Some components have two
u
jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional
u
-capable components.
• Connect only Onkyo components to
u
jacks. Connecting other
manufacturer’s components may cause a malfunction.
• Some components may not support all
u
functions. Refer to the
manuals supplied with your Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change
u
functions do not work.
Connecting Onkyo RI Components
1
Make sure that each Onkyo component is connected
with an analog audio cable (connection
G
in the
hookup examples) (
➔
page 15
).
2
Make the
u
connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape deck,
change the Input Display (
➔
page 35
).
L
R
ANALOG
AUDIO OUT
L
R
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock
Summary of Contents for HT-RC440
Page 75: ...Appendix En 75 Memo...
Page 119: ...Remote Control Codes 19 Memo...