En-2
■
Connection Using Digital Processing
Crossover Network (without Crossover
Network) Function
1.
Remove two screws to detach the switch cover plate.
2.
Flip up the both network changing switches.
3.
Connect the speaker to an amplifier with Digital Processing
Crossover Network (without Crossover Network) function as
shown below.
Tip
・
Refer to the Onkyo website for Digital Processing Crossover
Network (without Crossover Network) function.
http://www.onkyo.com/
・
Woofer-Squawker crossover frequency (INTERNAL
CROSSOVER): 450 Hz
Refer to page Ja-8 for circuit diagram.
Note
Flip down the both network changing switches when Digital
Processing Crossover Network (without Crossover Network)
function is not used.
2
1
EXTERNAL CROSSOVER
INTERNAL CROSSOVER
R
L
R
L
Red cord side
Red cord side
Right speaker
Left speaker
LOW-FREQUENCY
HIGH-FREQUENCY
Amplifier with Digital Processing Crossover
Network (without Crossover Network), etc.
Remove the
jumper bars
Caution
・
Make sure that the positive (+) and negative (-) wires or R and L wires are not touching
each other and also not touching the rear panel of the amplifier to avoid the circuit
damage.
・
Make sure to twist the core wire properly to prevent it from touching the rear panel of
the amplifier and causing the short.
Summary of Contents for D-509E
