Install Batteries
1. Open the battery cover.
3. Close the battery cover.
2. Insert 2 AAA batteries and check the positive and negative
polarity of the batteries is correct.
Preparation
1. Connect the power cable, signal cable and speaker input/output cables. Make sure speaker output is
not short circuited and turn volume knob counterclockwise to its minimum.
Remote Control Function
Model selection
CD/AMP
Please note that any key not
allocated a function is not intended
for use with this amplifier Pressing
those keys will have no response.
Input selection
Volume up
Volume down
Operation Procedures
2. Set the power switch
on the panel to ON and the signal input indicator will illuminate. In
approximately 3 seconds the relay will close. Turn the volume control clockwise slowly to the
desired position. The amplifier is now in normal operation mode.