Onicon FT-3100, Programming Manual

Page: 13 / 36

FT-3100 TRANSMITTER PROGRAMMING GUIDE
ONICON Incorporated 727.447.6140 Page 13 onicon.com
Diameter Unit Type [Diam = in]
Remote Mount Cable Unit Type [S.cable = ft]
Flow Rate Unit Type [FR unit = IMPERIAL]
Pulse 1 Unit Type [Pl1 unit = IMPERIAL]
Pulse 2 Unit Type [Pl2 unit = IMPERIAL]
Total Forward Flow Totalizer Unit Type [T+unit = IMPERIAL]
Total Forward Flow Totalizer Units [T+unit = Gal]
Total Forward Flow Totalizer Decimal Point Position [T+D.P. = X]
Partial Forward Flow Totaliazer Unit Type [P+unit = IMPERIAL]
Partial Forward Flow Totalizer Units [P+unit = Gal]
Partial Forward Flow Totalizer Decimal Point Position [P+D.P. = X]
Total Reverse Flow Totalizer Unit Type
[T-unit = IMPERIAL]
Total Reverse Flow Totalizer Units [T-unit = Gal]
Total Reverse Flow Totalizer Decimal Point Position [T-D.P. = X]
Partial Reverse Flow Totalizer Unit Type [P-unit = IMPERIAL]
Partial Reverse Flow Totalizer Units [P-unit = Gal]
Partial Reverse Flow Totalizer Decimal Point Position [P-D.P. = X]
Temperature Unit Type
[Temp.unit = °F]
Mass Units Enable [Mass units = OFF]
Specific Gravity Coefficient [Sg = kg/dm
3
X.XXXX]
This function sets the nominal diameter of the sensor body for U.S. (imperial) or
SI (metric) units. This setting changes the list of nominal diameters in SENSOR
menu (menu 1) [Diam. = ft XXX] from U.S to SI units.
To change the existing setting, press enter to access the function. Use the right
arrow key to change the selection. Press enter to accept the change and exit the
function. Press escape to exit the program mode. Table of Contents
This function sets the cable length measurement units for U.S. (imperial) or SI
(metric). This setting changes the way cable lengths are entered in SENSOR menu
(menu 1) [S.cable = ft XXX].
To change the existing setting, press enter to access the function. Use the right
arrow key to change the selection. Press enter to accept the change and exit the
function. Press escape to exit the program mode. Table of Contents
This function sets the list of flow measurement units for U.S (imperial) or SI
(metric).
To change the existing setting, press enter to access the function. Use the right
arrow key to change the selection. Press enter to accept the change and exit the
function. Press escape to exit the program mode. Table of Contents
Diameter Unit Type
[Diam. = in]
Remote Mount Cable Unit Type
[S.cable = ft]
Flow Rate Unit Type
[FR unit = IMPERIAL]
3.2 MENU 2 - UNITS