Instructions for height adjustment
Warnings
Tipping hazard.
Despite the nonslip coating of the
base, inappropriate movements may cause the stool
to slide outward and tip over. Do not stand or balan
ce on top of the stool. Do not use the ONGO®Kit as a
ladder. Do not use for children who cannot yet reach
the floor with their feet when sitting on the stool.
Danger, small parts.
Screws are used to connect the
individual extension elements. Please make sure that
they do not get into the hands of small children to
avoid the danger of being swallowed.
Proper use of the ONGO®Kit.
The ONGO®Kit has been
designed for dynamic, healthy sitting. It has not been
designed and manufactured for any other purposes.
Use the ONGO®Kit only for the intended purpose.
Use by one person only.
The ONGO®Kit was
designed and manufactured only for use by one
person at any time. If used by several persons
simultaneously it might collapse and cause
serious injuries.
Its maximum load is 120 kg or 264 lbs.
Use of force.
Any misuse and/or application of force
on the ONGO®Kit may result in serious physical injuries.
Seek medical advice before using.
Although
physicians were involved in the development and
testing of the stool, you should consult your doctor
or physical therapist regarding proper use in your
specific case, especially in case of acute back pain.
Packaging material.
Dispose of any packaging
material properly. Keep packaging material out of the
reach of children to avoid the risk of suffocation.
Materials
Seat cover: Knit microfiber made of 100 % polyester
Seat foam: CFCfree polyurethane foam
Body: Propylene
Surface of the base: TPE
Ball: PVC
All materials fulfil regulatory requirements for
nontox ic substances and durability.
Care
•
The microfiber cover may be cleaned with water
and/or commercially available cleaning products.
•
The body of the ONGO®Kit can be kept clean with
mild, diluted household cleaners and a soft cloth.
Do not use solvents or abrasive materials.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
To insert or remove an ex
tension element, remove
the four screws on the
bottom of the ONGO®Kit
with a Phillips head
screwdriver.
Loosen the outside body
(A) by pushing on the rim.
Move the rim over the
inner body (K).
And take it off.
Remove the three screws
on the bottom of the
inner body.
Now insert the extension
element (H) so that the
three cylinders fit into
the three indentations
(V).
Turn the three screws
firmly, but without
destroying the thread.
To reach the desired
height, repeat this step
or reverse it.
Then screw onto the
inner body the extension
element.
Put the inner body in the
recessions of the outer
body.
Finally screw both parts
together again.
ONGOKit_Bedienungsanleitung_US_Englisch.indd 2-3
10.04.13 12:28
