OneTech NT09-209N-V, Instruction Manual

Page: 2 / 12

NT09-209N-V, NT09-210C-H ENGLISH v.2.0
2
ATTENTION! PLEASE READ THIS MANUAL BEFORE USING THE TOOL.
IMPROPER USE OF TOOL MAY CAUSE INJURY AND/OR PROPERTY DAMAGE!
ONLY QUALIFIED AND SPECIALLY TRAINED PERSONNEL FAMILIED WITH THESE INSTRUCTIONS IS ALLOWED TO USE AND
MAINTENANCE OF THE TOOL.
This manual contains description, safety rules and all the information necessary for the correct use of the pneumatic tool.
The safety advice given in this manual is in addition to and does not replace the general safety regulations applicable in the
region where the Tool is used.
➢
Potential injury from moving parts.
➢
There may be an increased level of noise, vibration.
➢
Excessive dustiness of the air in the working area may occur.
GENERAL RULES OF OPERATION
•
When working with the tool always use personal protective equipment appropriate for the type of work performed (goggles,
impact resistant glasses, hand protection, body, etc.);
•
The employee's appearance must comply with safety requirements. Loose clothing, jewelry or long hair can be caught in the
rotating parts of the tool;
•
The rated speed of the accessories used must exceed the maximum indicated tool speed;
•
To ensure maximum performance and durability of the tool, the working pressure of the compressed air should be set
at 6,2 bar;
•
Do not operate the tool in an explosive environment containing flammable liquids, gases, or dust. During operation, sparks
may form, from which ignition is possible;
•
High noise levels can cause hearing loss. Timely maintenance will help avoid an increase in noise levels;
•
The tool may generate vibration during use. Prolonged vibration can damage hands and / or other parts of the body. In case
of any unpleasant sensations in the hands and wrists, you must stop working;
•
The flow of compressed air can cause serious injury. Never direct the air flow towards yourself or others. Do not use
compressed air to clean clothes;
•
Before starting work, check the compressed air supply and dust extraction hoses for damage, wear or other defects. Replace
immediately if found;
•
Do not carry the tool by the compressed air supply and dust extraction hoses;
•
Check screw connections before starting work. Tighten if necessary;
•
Possible sudden changes in movement during start-up and operation;
•
Do not try to lock the ON / OFF lever in the ON position. The lever should independently and freely return to the "OFF" position
after being released;
•
The workpiece to be processed must be securely fixed;
•
Always disconnect the tool from the compressed air line before changing abrasives, accessories, performing maintenance or
adjusting parameters;
•
Before installing on the tool, inspect the abrasives (accessories) for damage or defects.