40
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received,including interference that may cause
undesired operation.
NOTE: The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modifications or changes to this equipment. Such
modifications or changes could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions,
harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
may cause
The SAR limit of USA (FCC) is 1.6 W/kg
averaged over one gram of tissue. Device
types ONE A0001 (FCC ID: 2ABZ2-A0001)
has also been tested against this SAR limit.
The highest SAR value reported under this
standard during product certification for use
when properly worn on the body is 0.798 W/kg
and for head is 0.353W/kg.
Simultaneous RF exposure is 1.092W/Kg.
This device was tested for typical body
‐
worn
operations with the back of the handset kept
10mm from the body.
To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a
10mm separation distance between the user's
body and the back of the handset. The use of
belt
holsters and similar accessories
should not contain metallic components in its
assembly. The use of accessories that do not
clips,
‐
Reorient or relocate the receiving antenna.
‐
Increase the separation between the
equipment and receiver.
‐
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
-
Consult the dealer or an experienced radio/
TV technician for help.
