Pro 1500 / 2000 © O.A.S. 2010
13
XIII. Directions for Cleaning the Filter
All steps should be done with a dust mask and eye protection. Proper filter clean
-
ing should not be neglected. A dirty filter can affect dust collector operation and
filter life.
1. Compressed air from outside.
Blast air along pleats of the filter at about a 20 degree angle.
Blast air out and away from you or anyone in the general area.
Keep air nozzle at least 6” from filter. Closer blasts may dam
-
age material. This operation should be done with filter on the
unit. Dust is trapped inside filter so it will not make a mess.
Filter must be cleaned regularly or filter damage may
result. If gauge reaches 3, it is time to clean your fil
-
ter. Never allow gauge to reach 5. You could destroy
your filter. See page 14.
6”
XII. Wiring Instructions for Magnetic Starter
Follow wiring diagram on motor.
Always use a licensed, professional electrician.
Note: This Dust Collector is pre-
wired at the factory and need only
be plugged into a NEMA 6-20R
dedicated electrical receptacle.
#hp single phase only.
2. Empty Dust Bin.
Wait a few minutes for internal dust to settle then unscrew
thumb nuts from J-Hooks and remove dust bin. Empty dust
carefully. Replace dust bin. Do not over tighten thumb nuts.
Filter
J-Hook
Dust Bin
Thumb Nut