3.
4.
General Assembly Instructions
2. Turn cyclone upside-down and place it on the floor or
other flat surface. Turn drum lid over and align bolt holes in
lid with bolt holes in cyclone base. Put bolt through washer,
then put bolt and washer through lid from the underside
of lid and add another washer and attach with whiz nut.
Tighten nut and repeat with all six bolts. Thoroughly tighten
hardware to eliminate air leaks. (Fig. 2 & 4)
3. Put cyclone and lid on top of optional dust drum then
attach and seal with clamp ring. (Fig. 3)
1. Apply gasket around the inlet hole in the drum lid,
making sure that the gasket goes inside the bolt holes and
around the inlet hole. An air tight seal is extremely impor-
tant for good dust collection. Make sure ends of gasket
butt together and there are no gaps. (Fig. 1)
3.
2.
1.
4. When you attach the hose from your tool to the 5” inlet,
you may need to use a reducer depending on the size of
your tools’ dust colllection outlet.
4.
5.
5. Attach 6” hose to the Super Dust Deputy’s top outlet with
a hose clamp, then connect the other end to your collectors’
fan blower as shown in the diagram below.(Fig. 5)
6. Make sure there are no air leaks at the connections. Make
sure to check your dust drum frequently so you do not overfill
it.
7. You may need to use an
adapter to connect the 6”
flex hose to outlet. See ac-
cessories page. (Fig.6)
#DAO060000
Bolt
Washer
Nut
Flange
Gasket
Drum Lid
6.
Accessories
- Super Cartridge Filter Retrofit Kit
Catches the micro-fine dust.
Small footprint.
Quick clean out dust pan.
May be required for installation:
Elbows / Reducers
Flex Hose / Duct Hanger / Pipe Hangers
High Efficiency Filter Cartridge / Dust Drum
Filter Cap with Holes for Hanging / Hardware
High Efficiency Axtar Spun-Bonded Media
Teflon-Like Coating to Facilitate Dust Cake Release
Filter Media Captures 99.9% of Test Material
from 0.2 - 2 Microns @ 11 FPM / Accredited,
Independent Lab Tested
*Oneida reserves the right to change or modify specs and
system appearance without notice. Actual system appearance
may vary.
Optional
FXK010039
FXK010000
39” L x 13” D / 7” Inlet / 95 Sq. Ft.
62” L x 18” D / 8” Inlet / 130 Sq. Ft.
Part #
Description
Filter Media
Included
ASHRAE
Tested
7” or 8”
Holes for
Hanger
Straps
Holes for
Hanger
Straps
Patented
Internal
Silencer
Quick Release
Dust Pan
Super
Cartridge
Filter
39”
or
62”
13”
or
18”
HEPA Filter Retrofit Kit for
Single Stage Collectors.
Collector Not Included.
FXK011820
HEPA Filter Retrofit Kit
Part #
Description
Keep your shop clean by preventing ultra-fine dust from
blowing out of your single-stage bag collector and into your
shop air.
Add a best-in-filtration GE H12 HEPA filter to your current
single stage dust collector.
