OneAccess ONE100D/M, Installation Manual

Page: 55 / 67

ONE100D/M Chapter 6
Installation Guide Installing the ONE100D/M
55
6.1 Opening and closing the housing
When you want to change the DIP switch settings, you have to open and close the housing. This section
explains how to do so.
Opening the housing
To open the housing of the ONE100D/M, proceed as follows:
Closing the housing
To close the housing of the ONE100D/M, proceed as follows:
Step Action
1 Disconnect the external power supply.
2 Unfasten both rear panel screws and remove them.
3 Unclip the lower part of the front panel.
4 Remove the cover.
Step Action
1 Replace the cover.
2 Fix the lower part of the front panel.
3 Fasten both rear panel screws.
4 Reconnect the external power supply.