OneAccess ONE100D/M, Installation Manual

Page: 43 / 67

ONE100D/M Chapter 4
Installation Guide Interface description
43
4.4 LAN interface specifications
• Connector: RJ45 (EIA/TIA 568B)
• Cable to be used: standard Ethernet cable (shielded UTP Cat. 5)
• Applicable standards: IEEE 802.3 (10Mbps Ethernet), IEEE 802.3u (100Mbps Ethernet)
• Speed: 10/100 Mbps auto-sense
• DTE/DCE auto cross-over
• VLAN support (up to 12 VLANs)
• The following LEDs are available built-in on each Ethernet interface connector:
The following table shows the connector layout of the RJ45 Ethernet LAN interface connector:
Colour Description
Green • OFF: link inactive.
• ON: link active.
Yellow • OFF: no traffic in progress.
• ON: traffic in progress.
Pin Signal DTE DCE Figure
1 transmit (+) Out In
2 transmit (-) Out In
3 receive (+) In
4 not used -
5 not used -
6 receive (-) In Out
7 not used -
8 not used -