Installation figure and dimension for the whole turnstile ( mm )
52 0
52 0
8
2
0
8
2
0
2 4 0
2 4 0
10 0
10 0
（
)
This is the concrete floor
（
）
This is the wall
1) put the boom to the installing groove of the rotating platform.
2) put the pin of the boom into the pin hole of the rotating platform.
3) when the boom pins are stalled well, fasten them with the screws.
4
5
3) Pack the electricity wire and the internet wire by PVC tube and embed it in the
right position by concrete.
4) Open the housing of the turnstile, fasten the net in the base of the turnstile.
5) Connect the electricity wire, al l the wire from the control panel, the socket of
control panel and the protecting wire of the system.
5.2. Installation of the boom.
5.3. Before using the turnstiles
1) Definition of the left or right: When facing the turnstile, the booms rotate in
the right direction, this direction is defined the left. The booms rotate in the left
direction, this direction is defined the right .
2) Input socket : +12V electricity level signal or pulse width>100ms DC Pulse
signal driving current>10mA or Rs232 signal
3) adjust for single direction transit: adjust the screws of the single direction
machine. Lock the localized boom, then the turnstile will run will in one
direction.
4) Check whether the connection is correspondent with the connection figure.
Attention: Check all the sockets, whether they are loose or whether there is wire
connect to the ground. Make sure everything is well before power and debug it
5) Check the rotating direction of the motor: After powering the system, the
boom of the turnstile will automatically begin to rotate. When user faces the
turnstile, the boom should rotate in the right direction. If not, please transfer the
two wire-connection ports.
28
0
1235
14
0
1 0 9 2 . 6
5. Installation
5.1 Basement installation of the turnstile
1) check al l the spare parts according to the packing list.
2) After the whole turnstile has been installed, set the position for setting
the turnstile. Set the installing hole according to the size of the base of the
turnstile. Fasten the turnstile with four 4×M16 inflating bolts. The figure
for installing the turnstile on the ground is
as followed:
Installation figure and dimension for the whole turnstile ( mm )
（
)
This is the concrete floor
（
）
This is the wall
380
1
65
1
45
3
80
420
6) Check the position of the boom. After the power is on and the boom is up, the
boom should be at the level position and locked reliably. It can not be moved by
external strength, otherwise adjust the ZERO switch. Ways: (1) open the upper
case the turnstile. (2)Loosen the screws of the arrival switch by screwdriver.
Rotate the axis and rotate the boom to the level position. Move the making the
ray of the switch point to the middle of the gap of the spot-light switch plate.
(3)fasten the screws of the arrival-switch and closer the upper cover of the
housing.
5.4 . Attention
1) Other equipments can not be installed on the turnstile. Make sure the
ground-wire safe.
2) When the turnstile is used outdoors, please install something right up the
turnstile to protect form the rain and sunlight. The turnstile should be
forbidden to be installed without anything protecting from rain and sunlight.
6. Structure of the turnstile and working principle
