One Stop Systems, Inc. OSS-adaptPCI-PMC User Manual
Rev. A
3
Installation and Removal
1. Power down the host system.
2. Open the chassis according to your system documentation.
3. Let the power supply cool down, if necessary.
4. Remove the OSS-adaptPCI-PMC from the protective bag, observing proper ESD safety procedures.
Install the PMC Module
1. Press the PMC card’s bezel into the cutout in the adaptPCI-PMC I/O panel. The gasket around the PMC bezel makes a
tight fit to ensure an electromagnetic seal. Check that the bezel and gasket are pressed firmly into the carrier I/O.
2. Press the PMC card down onto the carrier so PN1–PN4 plug into JN1–JN4 on the adaptPCI-PMC.
3. Install four screws to secure the PMC card in place.
4. You may mount a PMC card on either a 32-bit carrier or a 64-bit carrier. However, do not mount a 64-bit PMC card on a
32-bit carrier, and then install it in a 64-bit PCI slot. This violates the PCI specification in regards to REQ64# and ACK64#,
and causes indeterminate results. See PCI Specification 3.2, Section 3.8.1.
Installing
the OSS-adaptPCI-PMC:
1. Insert the OSS-adaptPCI-PMC an open PCI slot. The adapter is a universal-keyed 64 bit 3.3V or 5V board.
2. Make sure that the adapter is well seated and tighten the screw.
3. Close the chassis according to your system documentation
4. Attach the ethernet cables.
5. Turn on power to the computer. Adapter installation is complete.
6. Reverse the above procedure to remove the boardSpecifications
PMC card
OSS-adaptPCI-PMC
two screws
JN2
JN1
PN2
PN1
two screws
OSS-adaptPCI-PMC
PMC card
two screws
two screws
