Page 2
For technical questions, please call 1-888-866-5797.
Item 56883
Specifications
Run Time
up to 8 hours
Length
22’
Battery
1x ‘AA‘ NiCd
IMPORTANT SAFETY INFORMATION
1.
Verify that installation surface has no
hidden utility lines before drilling, driving
screws, or digging to insert stake.
2. Place/mount the Rope Light to prevent
tripping or choking.
Keep out of reach
of young children and babies.
3. Install only according to these instructions.
Improper installation can create hazards.
4. Wear ANSI-approved safety goggles and
heavy-duty work gloves during installation.
5. Keep installation area clean and well lit.
6. Keep bystanders out of the area during installation.
7. Do not install when tired or when under
the influence of drugs or medication.
8. This product is not a toy. Do not allow
children to play with or near this item.
9. Use as intended only.
10. CONTAINS NICKEL-CADMIUM BATTERY.
BATTERY MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
11. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Selecting a Location
1. Select a mounting location that will receive full
sunlight as many hours in the day as possible.
2. Even partial shade will greatly hinder charging
and therefore limit operation time.
3. If the area has strong nighttime light sources, these
may prevent the light from turning on at night, or may
cause it to flicker instead of turning on completely.
4. Keep away from sprinklers.
Wall Mounting
1. Select a wall location without hidden
cables or utility lines. Turn off all power
in the wall for added safety.
2. Place the Wall Base (3) in the desired location
and mark through the mounting holes.
3. Set the Wall Base aside and drill holes in the marked
locations appropriate for the Wall Anchors (5b).
4. Insert the Wall Anchors into the holes, align
the holes in the Base with the Anchors, and
secure it in place with the Wall Screws (5a).
5. Attach the Panel Connector (2) to the Wall Base (3).
6. Attach the Solar Panel (1) to the
slots on the Panel Connector.
