Warnings
- Do not use rough textured cleaning tools or highly corrosive
cleaners when cleaning your LED Lights. These tools and
chemicals will damage the product. ONLY use a soft damp
cloth and non corrosive cleaners.
- Do not scratch the LED strips or use sharp objects on them.
- Do not permanently bend, twist, or screw through the LED
strips as this will damage the LED’s internal components.
- Do Not pull or snap with excessive force, this will damage
the product.- If the product is damaged or wires are frayed
or damaged, do not use the product. If your product arrived
in this condition, contact us for a replacement.
- Recommended temperature is between 10°F to 120°F. Do
not use in extreme heat or cold.
- Once the product has come to the end of its life please
recycle the components. Ask your local retailer for proper
disposal methods.
Packaging Contains
- 1 Piece 70cm USB cable
- 1 Piece 24 key remote controller
- 3 Pieces 4-pin connection cables
- 6-pieces 4-pin connectors
- 4 piece 50 cm strip light, 30 LED per piece, 5v,
p65 waterproof 5050 RGB LED Strips
- 1 -
- 2 -
- 3 -
1. Clean the surface of residue and dust
3. Place the LED strips in the location you desire, pressing
firmly and sliding your finger along the strip to ensure a
secure attachment.
Installation Steps
2. Remove the protective film covering the adhesive backing
on your LED Strips
*IF THE STRIPS ARE NOT CONNECTED PROPERLY
THEY WILL NOT WORK OR APPEAR DULL.
*IMPORTANT:
Before beginning, look at your strips orientation. For correct
connection make sure to line-up the “+” to “+” between
strips and “ ” to “+” when using the connection cables.
See below for example:
Installation and User Manual
+1 (310)-645-6400
www.one-products.com
Promounts
20218 Hamilton Ave,
Torrance CA 90502
OTB04
