O
NE
F
OR
A
LL
8L U
NIVERSAL
R
EMOTE
C
ONTROL
WITH
L
EARNING
12 Programming Favorite Channel Scan
proceed to the next channel up
and cycle through all channels on
the selected device.
•
If
Favorite Channel Scan
has not
been set up, scanning will start
with the current channel, then
proceed to the next channel up
and cycle through all channels on
the selected device.
3.
To stop scanning channels at any time,
press any key once.
PROGRAMMING FAVORITE
CHANNEL SCAN
In the
TV
,
VCR
,
DVD
or
CBL/SAT
mode, you
can store a list of up to 10 favorite channels,
in any order, that will be immediately
scanned when you press
FAV
(see “Using
Channel Scan” on page 11).
NOTE:
Only channels of one mode can be
stored for Favorite Channel Scan.
1.
On the remote control, press
TV
,
VCR
,
DVD
or
CBL/SAT
once.
2.
Press and hold
SET
until the LED (red
light) blinks twice, then release
SET
.
3.
Enter
9 9 6
. The LED will blink twice.
4.
Use the keypad to enter a favorite
channel number (e.g.,
031
). Then press
SET
once.
NOTE:
If the original remote control required
pressing an
ENTER
key to change the channel,
also press the
ENTER
key after the channel
number (e.g.,
0 3 1 ENTER
).
5.
If desired, repeat step 4 (in this
section) for each favorite channel to be
stored, up to a total of 10 channels.
NOTE:
If you try entering more than 10
channels, the remote control will
automatically exit programming.
6.
To exit programming, press and hold
SET
for 3 seconds. The LED will blink
twice.
USING LEARNING
The One For All 8L Universal Remote
Control with Learning (URC-8820 B00)
includes a Learning feature so you can add
functions that are unique to your home
entertainment devices (e.g.,
DVD EJECT
).
However, there are some considerations.
L
EARNING
P
RECAUTIONS
•
Your original remote controls must be
in working order for learning to work
properly.
•
Learned keys are mode specific, so
each one can store a unique function
for each mode.
•
Learned keys can be used in macros
(see “Using Macros” on page 9).
•
Do not use the following keys for
learning: Device Keys,
SETUP
,
FAV
, or
Record (
•
) Key.
•
Learning capacity is approximately 50
to 70 keys, depending on the code
being learned.
•
If both learned and keymoved
functions are assigned to the same key,
the last programmed function is
stored.
•
A learned function cannot be used as a
source for Keymover (see “Using
Keymover” on page 14).
•
Certain device codes are not learnable
including multi-frequency types, some
OFA 8L with Learning Owners Manual.fm Page 12 Monday, January 24, 2005 10:04 AM