如果跑带左偏,则顺时针调节左
边螺丝或逆时针调节右边螺丝
如果跑带右偏,则顺时针调节右
边螺丝或逆时针调节左边螺丝
If deviate to the right, then
adjust the screw on the right side
clockwise or the screw on the left
side anticlockwise.
If deviate to the left, then adjust
the screw on the left side clockwise
or the screw on the right side
anticlockwise.
2. Lubricating methods
To check if device need more lubricate catch up the running belt and touch the central part of the back of the belt with hand.
If the belt is with silicon resin (a bit sense of dampness) inside, this means no lubricant is needed; if the running board is dry and
you feel no silicon resin inside, means lubricant is needed.
A. Steps for coating the running board with lubricant: (see the picture)
B. Stop the rotation of the running belt and fold the machine.
C. Put the oil bottle as nearly as possible into the center of the inner sife of running belt, apply the oil, then apply the oli at the
each side of the running belt from the inside. Turn on the device with speed 1K M/H to spread silicone resin; and step on the belt
from left to right for a few minutes, then the silicone resin will be completely absorbed by the belt.
3. Running belt tension adjustment
All treadmills’ belts should be adjusted before leaving the factory and after the installation, however, after it is used for
a period,
looseness may occur. Adjust the belt and bolts synchronously from both the left and right side in a clockwise direction and same
angle; if the running belt is too loose, it can slip from the rollers; if the belt will be too tight, it will be easy to increase the motor
load and damage motor, running belt, roller, etc.
Summary of Contents for BE4515
Page 1: ...BE4515...
