NCD57253GEVB
www.onsemi.com
11
Test 3 – Typical Performance Waveforms –2 Channels Complementary Driver without Added Dead Time
The NCD57253 can work as 2 channel complementary driver with single channel input without affecting the dead time.
To set the board as 2 channel driver, use this setup as a reference.
Make sure the power supplies & outputs of signal generators are powered off / disabled channel
1. VIN SET
a. For powering outputs by using external power supplies
−
open jumper
b. For using 5 V dc
−
dc converter – Set jumper to 5 V
c. For using different input voltage dc
−
dc converter – Set jumper to VCC
i. External power supplies with appropriate voltage need to be connected to VCC pin
2. ANB SET – Set to ON
3. DT SET – Set to OFF
4. B
−
IN SET – Set to INA
5. POWER UP the setup
(Legend:
C1 – Input A (INA)
,
C2 – Output A (G
−
A)
,
C3 – Input B (INB)
,
C4 – Output B (G
−
B)
)
Figure 10. INPUT and OUTPUT Signals
