ON Semiconductor MT9V113PACSTCH-GEVB, User Manual

Page: 3 / 5

MT9V113PACSTCH − GEVB
www.onsemi.com
3
Jumper Pin Locations
The jumpers on headboards start with Pin 1 on the leftmost
side of the pin. Grouped jumpers increase in pin size with each
jumper added.
Figure 5. Pin Locations for a Single Jumper. Pin 1 is Located at the Leftmost Side
and Increases as it Moves to the Right
Pin 1
Pins 1 − 4
Figure 6. Address Switch Locations in their Default Positions. The first Switch(ADR0)
and the second Switch (ADR1) of SW3 are set to ON
ADR1
ADR0
Figure 7. Switch Descriptions od Switch SW4 in their Default Positions.The first Switch (STDBY)
is Set OFF while the Second Switch (OE_N) is Set to ON
OE_N
STDBY
Jumper/Header Functions & Default Positions
Table 1. JUMPERS AND HEADERS
Jumper/Header No. Jumper/Header Name Pins Description
JP1 FLASH Open (Default) Connects to external flash
J4 GPIO[1:0] Open (Default) Connects to GPIO signals
J9 +VDDIO
1 − 2 (Default) Connects to on-board +3V3_VDD power supply
Open External power supply connection
J10 +3V3_VAA
1 − 2 (Default) Connects to on-board +3V3_VAA power supply
Open External power supply connection
J13 +1V8_VDD
1 − 2 (Default) Connects to on-board +1V8_VDD power supply
Open External power supply connection
J14 ATEST Open (Default) For test/debug
SW1 RESET N/A When pushed, 400 ms reset signal will be sent to MT9V113