ON Semiconductor EZAIRO 7160 SL, Manual

Page: 3 / 17

EZAIRO 7160 SL HYBRID
www.onsemi.com
3
Table 1. ABSOLUTE MAXIMUM RATINGS
Symbol Parameter Min Max Unit
VBAT Power supply voltage 2 V
RCVRBAT Output drivers power supply voltage 2 V
VDDO
2
I/O supply voltage 3.3 (Note 1) V
Vin Voltage at any input pin GNDC − 0.3 VDDO + 0.3 V
DGND, AGND, HGND Digital and Analog Grounds 0 − V
T functional Functional temperature range (Note 2) − 40 85 ° C
T operational Operational temperature range (Note 2) 0 50 ° C
T storage Storage temperature range − 40 85 ° C
Caution: Class 2 ESD Sensitivity, JESD22 − A114 − B (2000 V)
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. In some applications, VDDO can be higher than 2.1 V (maximum 3.3 V). In such cases, the user must set the VDDM voltage at a minimum
of 1.1 V
2. Electrical Specification may exceed listed tolerances when out of the temperature range 0 to 50 ° C
Electrical Performance Specifications
The tests were performed at 20
°
C with a 1.25 V supply voltage and 4.7
W
series resistor to simulate a nominal hearing aid
battery. The system clock (SYS_CLK) was set to 5.12 MHz and an audio input sampling frequency of 16 kHz was used.
Parameters marked as screened are tested on each chip.
Table 2. ELECTRICAL SPECIFICATIONS
Description Symbol Conditions Min Typ Max Units Screened
OVERALL
Supply Voltage VBAT Supply voltage measured
at the VBAT pin
1.18
(Note
3, 4)
1.25 2.0 V
I/O Supply Voltage
Domain 2
VDDO
2
1.05 − 3.3 V
Current consumption I
VBAT
Filterbank: 30% load CFX:
100% load SYS_CLK:
10.24 MHz, No activity on
the RSL10
− 700 − m A
Ezairo Pre Suite firmware
bundle running at15.36 MHz,
all algorithms active, no
transducers connected, no
activity on the RSL10.
− TBD − m A
Stand by current I
stb
Using ON Semiconductor’s
macro
40 120 m A
3. In order to be able to use a VBAT Min of 1.1 V, the following reduced operating conditions for the RSL10 should be observed:
− Maximum Tx power 0 dBm.
− SYSCLK
≤
24 MHz.
− Functional temperature range limited to 0 − 50 ° C
The following trimming parameters should be used:
− VCC = 1.10 V
− VDDC = 0.92 V
− VDDM = 1.05 V, will be limited by VCC at end of battery life
− VDDRF = 1.05 V, will be limited by VCC at end of battery life. VDDPA should be disabled
RSL10 should enter in end − of − battery − life operating mode if VCC falls below 1.03 V. VCC will remain above 1.03 V if VBAT ≥ 1.10 V under
the restricted operating conditions described above.
4. Min VBAT = 1.05 V if RSL10 is disabled