EVBUM2511/D
www.onsemi.com
3
GETTING STARTED
Introduction
This chapter is about setting up the hybrid demonstrator
board for use. You have to provide it with power and connect
it to your computer. If you want to program the nRF51822
radio IC and the Ezairo 7100 on the board, you need some
software development tools. Finally, if you would like to
evaluate the volume control, this chapter describes
connecting to the audio input/output.
You need a programming box to connect the hybrid
demonstrator board to a computer. Supported programmers
are:
•
Promira Serial Interface from Total Phase, Inc.,
driver version 1.3.6
•
Communication Accelerator Adaptor (CAA),
driver version 1.3
•
HI−PRO, driver version 2.0.0.4
•
DSP Programmer Version 3
•
NOAHlink
•
BlueGiga (Pre Suite only)
Powering the Ezairo 7150 SL Motherboard
1. Connect the programmer to the header J2 on the
motherboard.
2. Short the header VBAT−I.
3. Short the top row (pins 1 and 2) of PSU−SEL.
This will cause the system to be powered by
a battery connected to J3. Additional powering
options are noted in “Selecting the Power Supply”
section.
4. Switch SW3 to ON.
