ON Semiconductor ASX340AT, User Manual

Page: 4 / 6

ASX340AT2C00XPEDH3 − GEVB
www.onsemi.com
4
Table 1. JUMPERS AND HEADERS
(continued)
Jumper/Header No. Description Pins Jumper/Header Name
P14 S_CONFIG 2 − 3 (Default) Sensor Operating in AUTO Mode
1 − 2 Sensor Operating in HOST Mode
P15 SPI_FLASH_SELECT 1 − 2 (Default) SPI FLASH (512 Kbit) Selected
2 − 3 SPI FLASH (512 Kbit) Not Selected
P16 S_CONFIG_FLASH
2 − 3 (Default) Sensor Operating in Host/Auto CONFIG Mode
1 − 2 Sensor Operating in FLASH Mode
P17 SPI_SOCKET_SELECT 2 − 3 (Default) SPI SOCKET Not Selected
1 − 2 SPI SOCKET Selected
P18 SPI Program Open (Default) For Connection to External SPI Memory Programmer
P19 JTAG I/F Open (Default) For Debug/Test
P20 CLK_SELECT 1 − 2 (Default) Connects to On-board Oscillator
2 − 3 Connects to HB_MCLK from Demo 3 Baseboard
P21, P22 OSC/XTAL_SELECT
P21 2 − 3,
P22 Closed
(Default)
Selects Crystal as Sensor Input Clock
P21 1 − 2
P22 Open
Selects Oscillator as Sensor Input Clock
P23 EEPROM ADDR
1 − 2 Closed,
3 − 4 Open
(Default)
EEPROM Address Set to 0xA8
1 − 2 Open,
3 − 4 Open
EEPROM Address Set to 0xAC
1 − 2 Open,
3 − 4 Closed
EEPROM Address Set to 0xA4
1 − 2 Closed,
3 − 4 Closed
EEPROM Address Set to 0xA0
P24 BEAGLE I/F Open (Default) For Debug/Test
P25 BEAGLE_SELECT 1 − 2 (Default) BEAGLE I/F Disabled
Open BEAGLE I/F Enabled
P33 +VDDIO 1 − 2 (Default) S2V8_VDDIO_HB
P35 +VDD_EXT 2 − 3 (Default) Connects to On-board +VDD_EXT Power Supply
1 − 2 External Power Supply Connection
P36 GPIO13 2 − 3 (Default) Selects Device Address to 0x90
1 − 2 Selects Device Address to 0xBA
P37 GPIO12
2 − 3 (Default) Selects Device Address to 0x90
1 − 2 Selects Device Address to 0xBA
SW1 RESET N/A When Pushed, 240 ms Reset Signal will be Sent to
ASX340