ON Semiconductor AR0841CS, User Manual

Page: 3 / 5

AR0841CSSC32SMFAH3 − GEVB
www.onsemi.com
3
Jumper Pin Locations
The jumpers on headboards start with Pin 1 on the
leftmost side of the pin. Grouped jumpers increase in pin
size with each jumper added.
Figure 5. Pin Locations for a Single Jumper. Pin 1 is Located at the Leftmost Side
and Increases as it Moves to the Right
Pins 1 − 4 Pin 1
Figure 6. Pin Locations and Assignments of Grouped Jumpers.
Pin 1 is Located at the Top-Left Corner and Increases in a Zigzag Fashion Shown in the Picture
Pins 1 and 2 Pin 1
Pins 3 and 4
Pins 5 and 6
Pins 7 and 8
Pins 9 and 10
Jumper/Header Functions & Default Positions
Table 1. JUMPERS AND HEADERS
Jumper/Header No. Jumper/Header Name Pins Description
P1 VPP Open (Default) For Connection to ExVPP Power Supply
(OTPM Programming)
P2 AF_VCM Open (Default) For Connection to External AF VCM
P3 TEST
2 − 3 (Default) Normal Mode
Open Test Mode
P4 ATEST1 1 − 2 & 3 − 4 (Default) Normal Mode of Operation
P5 FLASH 1 +5V0
2 GND
3 FLASH
4 +3V3
P6 GPI2 Open Various Sensor Option Settings
P7 SHUTTER Open (Default) Connection to External Shutter
P8 GPI3 2 − 3 (Default) Normal Operation/Master in Multi-camera Mode
1 − 2 Slave in Multi-camera Mode
P22 CLK_SELECT 1 − 3 & 6 − 8 (Default) Select On-board 24-MHz Oscillator and Enable
Master Clock Output
3 − 5 Select Demo 3 Baseboard Clock
2 − 4 Select Slave Clock (for Slave Sensor in
Multi-camera Mode)