Note:
Caution:
We recommend that the bulb be replaced by an OMS trained technician or by OMS . If
neither option is open to you:
a. loosen the 4 Titanium screws very slowly
b. set O Rings aside in a clean area
c. remove old and install new bulb
d. reverse assemble lightly lubricating O-Rings
What to do in case of flooded light:
Turn off immediately. Immerse entire light in a 5 gallon pail of distilled or DI water. Hold
battery canister at the bottom of the pail of water and unscrew bottom cap (the cap without
the cord). This will allow any pressure build up to vent safely. Disassemble all parts and
place in distilled water, remove and dry thoroughly. Return to OMS by obtaining an RMA
number.
Procedure for service or making a warranty claim:
Contact OMS for a return authorization number and state reason (i.e. service, repair or
warranty issue).
CALL 1-845-692-3600
Batteries: Standard 4.4 Ah Lithium Ion battery
Optional 8 Ah NiMH battery
Burn time: 4.5 hrs Approximate
Weight: 2.2 lbs
4 Ah Canister size: 7 5” length x 2.38 “Outside diameter
Burn time: 9 hrs. Approximate
Weight: 4.5 lbs
8 Ah Canister size: 15.0” length x 2.38” Outside diameter
Special Charger supplied
®
®
®
®
4.4 Amp Hour battery
8 Amp Hour battery
Page 4
Can be used with either (a.) or (b.)
b
a
Page 5
WARNING
and CAUTION
Use only underwater
DO NOT look directly into lamp - can cause severe eye damage.
Use only the OMS charger.
FIRST time the HID lamp is turned on - allow 5 minutes warm up time
before turning off.
To prevent damage to the lamp and optimize lifetime, do NOT turn lamp
on and off repeatedly.
If lamp is accidentally turned off, wait 15 seconds for it to cool (minimum 10
seconds) before restarting. This will help insure maximum lamp life. HID, like
other arc lamps, lose most of their life during the ignition-start-up.
Constant on-off-on-off use or shutdown prior to warm-up time (approximately 3
minutes) may damage the lamp.
Caution: Do not drop or bang light head. HID lamps are fragile and are very
susceptible to burnout or breakage due to shock.
When traveling or shipping, always disconnect the battery and engage switch lock
to prevent accidental activation of the light. Failure to disconnect the battery
during travel and/ or when the light is in close proximity to combustible materials
like dive gear, may result in fire damage. (see instructions *removing battery)
®
Mounting canister:
Side of back plate (a.), bottom of back plate (b), belt mount (c), top of
valves (d.), nested between double tanks (e)
