![background image](http://html.mh-extra.com/html/omron/zx2-series/zx2-series_user-manual_1633407045.webp)
Steps and Warpage
45
ZX2 User’s Manual
INTRODUCTION
BASIC
SETUP
PREPARATION
FOR
MEASUREMENT
TROUBLE-
SHOOTING
INDEX
CONTENTS
SETTING
TRANSITION
CHARTS
FLOW OF
OPERATION
MAIN
APPLICATIONS
& SETTING
METHODS
DETAILED
SETTINGS
SPECIFI-
CATIONS
Height
Double
Sheet
Detection
Positioning
Eccentricity
and Surface
Deflection
Steps
and
Warpage
Thickness
Steps and Warpage
Procedure for setting up steps and Warpage
1
Sensor installation/wiring
Has the Sensor been installed and wired?
(See page 23.)
Connect two Amplifier Units with a Calculating Unit in between. (The calculation
result is displayed and output on the CH2 Amplifier Unit.)
Set the reference workpiece in place, adjust the position of the Sensor Head while
looking at the digital display values on the Amplifier Unit or the indicators on the
Sensor Head so that each of the heights to be measured is near the measuring
center distance, and install the Sensor Head at this position.
2
Set to the MENU mode
Button
Operation
Display
Description of Operation
Explanation of
Selection Menu
Hold down the
button for
three seconds to switch to the
MENU mode.
Press the button to display
.
CH2
CH1
CH2
Arbitrary setting
Required setting
Set to the MENU mode
2
Response time setting
3
Sensor installation/wiring
1
Smart Tuning
4
8
Return to RUN mode
Setting completed
7
Threshold setting
5
2-sensor operation (A-B)
6
Mutual interference prevention
Required
Required
Select the desired mode to set
the measurement conditions in.
Hold down for
3 seconds
Lit
Press to display
.