Setting the Output Conditions
ZW User's Manual
251
Senso
r con
trol
ler ope
ra
ti
ons
9
Setting the Zero Reset Memory
Setting the Zero Reset Memory p.104
As an example, here is an explanation of the procedure for selecting the "ON" (enabled) zero reset memory
setting.
Operating procedure
Steps
Key operation
Display
Description
1
Press and hold the
key for two seconds to enter the FUN
mode.
2
Press the
/
keys to select "SYSTEM" and press the
key.
3
Press the
/
keys to select "ZER.MEM" and press the
key.
4
Select zero reset memory ON/OFF.
The current setting value is displayed on the sub-display.
Press
/
key to enter editing mode and the sub-display blinks.
In this example, select "ON" and press the
key.
5
Press the
key for two seconds to enter the RUN mode.
Summary of Contents for ZW-C1*T
