Setting Measurement Items
ZW User's Manual
231
Senso
r con
trol
ler ope
ra
ti
ons
9
9-7 Setting Measurement Items
Measuring the Height
As an example, here is an explanation of the procedure for measuring the height of the surface (2nd surface)
below a transparent object (as shown in the diagram on p.79).
Operating procedure
Steps
Key operation
Display
Description
1
Press and hold the
key for two seconds to enter the FUN
mode.
2
Press the
/
key to select MEAS, then press the
key.
3
Press the
/
key to select TASK1, then press the
key.
4
Press the
/
keys to select "ITEM" and press the
key.
5
Press the
/
keys to select "HEIGHT" and press the
key.
6
Select the measurement surface.
EDGE1 to EDGE4: 1st surface to 4th surface
PEAK: Peak
"SUR" is displayed on the main display and the current setting value
is displayed on the sub-display.
Press
/
key to enter editing mode and the sub-display blinks.
In this example, select "EDGE2" and press the
key.
7
Press the
key for two seconds to enter the RUN mode.
Summary of Contents for ZW-C1*T
