Omron ZW-7000 Series, User Manual

Page: 124 / 336

Setting Sensing
122
ZW-8000/7000/5000
User's Manual
4-1 Setting Sensing
Setting the Measurement Cycle
Set the measurement cycle. Extending the measurement cycle allows you to measure workpieces with lower
reflectivity.

Multi View Explore : [Bank Group] | [(Bank data name)] (double-click)
→
Edit pane : [Sensing setting] icon ( )
→
Sensing settings window : [Operating mode]
1
Set [Measurement cycle].
If changing the extension fiber cable length setting causes the setting value of the measurement cycle to exceed the
maximum value, the setting value is automatically changed to the maximum value.
Item Setting item Setting value Description
RUN mode Measurement
Cycle Refer to the table below. Set the measurement cycle.
Sensor Controller
type Extension fiber cable
length Minimum value (1 area
mode) [µs.] Minimum value (2 area
mode) [µs.] Maximum value
[µs.] Initial value [µs.]
ZW-8000
@
none 60 150 7500 1000
2 m 6500 900
5 m 4500 800
10 m 3500 700
20 m 2500 600
30 m 1500 500
ZW-7000
@
none 20 40 400 200
2 m 400 200
5 m 400 200
10 m 250 100
20 m 160 80
30 m 120 60
ZW-5000
@
none 80 80 1600 800
2 m 1600 800
5 m 1450 700
10 m 950 450
20 m 550 250
30 m 400 200
The measurement cycle can also be set by the operating keys on the Sensor Controller.
You can set the Measurement cycle by using key operation of the Sensor Controller p.222.
Important
Note